Dittmann Center 116

Please be sure to read all directions carefully before attempting to use the equipment. We strongly recommend that you attend a training session or request a tutorial well in advance of your class. To set up a tutorial or find out about training sessions, contact the IIT HelpDesk at Extension 3830. We also recommend that you take time to test out your materials prior to your class time.

Table of Contents

Projecting the Macintosh Computer

  1. Turn on the iMac by pushing the power button on the front (round button on the base of the unit towards the back on the right side)
  2. Turn on the Proxima projector by pushing the "power" button on top of the projector. The projector will count down as it warms up. If you do not see the computer screen projected after the warm up period, push the "input" button on top of the projector until the desktop appears on the screen.
  3. If the image is not in focus, use the "focus" knobs located above the lense to adjust the size and focus of the image
  4. The Web can be accessed by double-clicking the Netscape Communicator icon on the desktop (assuming that step 6 has been followed)
  5. Sven (i.e. "H: Drive" for PC users) can be accessed by double-clicking on the "Connect to Sven" icon on the desktop and entering your St. Olaf username and password

Shutting Down the Cart

  1. If you are using the Mac, go to the Apple menu and select Shut Down
  2. Push the "power" button on the top of the Proxima Projector TWICE
  3. Let the projector cool down (approximately two minutes until the fan quiets)
  4. Unplug the Ethernet and power cords

Troubleshooting Tips

No picture from the projector:

  • Make sure that the lens cap is off
  • Make sure that the red power button at the back of the projector is on when you push the power button on top of the projector

No network:

  • Make sure that the Ethernet cord is plugged into a jack with a green dot next to it
  • Make sure that the Ethernet cord is plugged into the back of the Mac
  • Go to the Apple menu, select Control Panels and then AppleTalk. Under Connect via, make sure that Ethernet is selected.
  • Go to the Apple menu, select Control Panels and then TCP/IP. Under Connect via, make sure that Ethernet is selected. Under Configure, make sure that Using DHCP Server is selected.

 

Back to Top | Classroom Technology Homepage