Science Center 378
July 2006
Common Sense Reminders
- Do NOT adjust any item labeled "DO NOT TOUCH"
- When possible, insure the technology works before class time.
- When in doubt, ask.
- After following the instructions, if you still have questions or problems operating the system, please contact the IIT Helpdesk (helpdesk@stolaf.edu or x3830).
Table of Contents
- Turning on the System
- Using/Displaying the Components
- Turning Off the System
1. Turning on the System
- Turn on the power to the rack unit: switch labeled “POWER” in the upper right corner of the rack)
- Turn on the power to the projector: hold in the black button on rack labeled “DISPLAY POWER” until the green light begins to blink (for 2 or 3 seconds). The green light and the selected input will continue to blink for 20-30 seconds as the projector warms up.
- Press the “MUTE” button to blacken the screen when not using the technology. Press the “UMUTE” buttons on the display panel to the screen to the desired input
- To use the Lights at the top of the rack, pull each light out and set the Light Power switch to the desired output “high or low”
2. Using/Displaying a Component
2.1 ELMO Document Camera
- Turn on the system as described in the first section
- Turn on the ELMO document camera on top of the table by flipping the switch labeled “POWER”
- Unfold the two lights
- Release the lock button at the back left of the ELMO and raise the camera head to its full height
- Push the “POWER” button on the small LCD monitor on top of the document camera
- Push the “ELMO” button on the rack
- Place the object or text that you want to project on the glass of the camera
- Enlarge or reduce the size of a projected object by using the “TELE” and “WIDE” buttons on the ELMO
- If an object is out of focus, press the “AUTO FOCUS” button
2.2 Computer
- Turn on the Gateway computer located in the under the VCR/DVD player.
- Push the “Computer” button on the top panel of the rack to display the computer.
- To hear sound, adjust the volume using the volume control by turning the Volume button to the desired volume.
- To use the external monitor with the computer, roll the cart with the monitor over to the counter and plug in the power and monitor cable into the Monitor input located on the back of the counter (side facing the students).
2.3 Playing an Audio CD
- Start up the computer as described in the previous section.
- Insert an audio CD into the CD-Rom Drive (it should automatically begin).
- Adjust the volume using the volume control by
turning the Volume button to the desired volume.
2.4 VCR
- Turn on the system as described in the first section
- Turn on the VCR in the rack by pressing the POWER button
- Push the “VCR” button on the Video Switcher on the top shelf
- Insert the tape or DVD into the VCR/DVD player
- Push the play button
The VCR controls are on the right side of the player and the DVD controls are on the left side of the player - Adjust “Volume” on the receiver as needed
2.5 Laptop
- Turn on the system as described in the first section
- Cables can be found in the drawer. Plug the attached video cable into the back of the laptop (video out) and to the laptop input on the back of the counter
- Plug the attached audio cable into the back of the laptop (audio out) and to the audio input on the back of the counter
- Turn on the laptop
- Push the “LAPTOP” button on the rack
3. Turning Off the System
- Turn off any piece of equipment that you were using
- Press and hold in the “DISPLAY POWER” button on the rack for 2-3 seconds (until the button blinks)
- The button will continue to blink as the projector cools down (approx. 2 minutes) and then go dim; it is VERY IMPORTANT that the projector be allowed to cool down
- Flip the main “POWER” switch in the upper right corner of the rack